[2017 New Updated] The Most Effective Cisco CCNP Switch 300-115 Dumps Verison 2.0 Exam Questions Preparation Materials Youtube Try

Has anybody attempted the Cisco 300-115 dumps exam? “Implementing Cisco IP Switched Networks“, also known as 300-115 exam, is a Cisco certification which covers all the knowledge points of the real Cisco exam. The Most Effective Cisco CCNP Switch 300-115 dumps verison 2.0 exam questions preparation materials Youtube try. Pass4itsure Cisco 300-115 dumps exam questions answers are updated (456 Q&As) are verified by experts.

The associated certifications of 300-115 dumps is CCDP. Pass4itsure latest cisco 300-115 ROUTE exam actual questions and real exam questions are very close. You may have also seen on other sites related https://www.pass4itsure.com/300-115.html dumps training materials, but will find their Source Pass4itsure of you carefully compare.

Exam Code: 300-115
Exam Name: Implementing Cisco IP Switched Networks
Q&As: 456

[2017 New Updated Pass4itsure 300-115 Dumps From Google Drive]: https://drive.google.com/open?id=0BwxjZr-ZDwwWLW41Sk5QSDdPTFU

[2017 New Updated Pass4itsure 200-310 Dumps From Google Drive]: https://drive.google.com/open?id=0BwxjZr-ZDwwWajNRNzNfaDllX3M

300-115 dumps

Pass4itsure Latest and Most Accurate Cisco 300-115 Dumps Exam Q&As:

A network engineer must set the load balance method on an existing port channel. Which action must be done to apply a new load balancing method?
A. Configure the new load balancing method using port-channel load-balance.
B. Adjust the switch SDM back to “default”.
C. Ensure that IP CEF is enabled globally to support all load balancing methods.
D. Upgrade the PFC to support the latest load balancing methods.
300-115 exam 
Correct Answer: A
EtherChannel balances the traffic load across the links in a channel through the reduction of part of the binary pattern that the addresses in the frame form to a numerical value that selects one of the links in the channel. EtherChannel load balancing can use MAC addresses or IP addresses, source or destination addresses, or both source and destination addresses. The mode applies to all EtherChannels that are configured on the switch. You configure the load balancing and forwarding method with use of the port-channel load-balance {dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac} global configuration command.
Refer to the exhibit.
300-115 dumps

A network engineer investigates a recent network failure and notices that one of the interfaces on the switch is still down. What is causing the line protocol on this interface to be shown as down?
A. There is a layer 1 physical issue.
B. There is a speed mismatch on the interface.
C. The interface is configured as the target of the SPAN session.
D. The interface is configured as the source of the SPAN session.
E. There is a duplex mismatch on the interface.
Correct Answer: C
With the SAPN destination port, the state of the destination port is up/down by design. The interface shows the port in this state in order to make it evident that the port is currently not usable as a production port. This is the normal operational state for SPAN destinations.
While doing network discovery using Cisco Discovery Protocol, it is found that rapid error tracking is not currently enabled. Which option must be enabled to allow for enhanced reporting mechanisms using Cisco Discovery Protocol?
A. Cisco Discovery Protocol version 2
B. Cisco IOS Embedded Event Manager
C. logging buffered
D. Cisco Discovery Protocol source interface
E. Cisco Discovery Protocol logging options
300-115 dumps 
Correct Answer: A
CDP Version 1 — This is the first version of CDP which was used for the discovery of Cisco devices in the network. This version is mainly used for backward compatibility. CDP Version 2 — This is the most recent version of CDP which has enhanced features such as rapid reporting mechanism, which is used to track down errors and minimize costly downtime. It allows you to track instances even if the native VLAN ID or port duplex states do not match between connecting devices. This  is the default version on all switches.
Which technique allows specific VLANs to be strictly permitted by the administrator?
A. VTP pruning
B. transparent bridging
C. trunk allowed VLANs
D. VLAN access-list
E. L2P tunneling
Correct Answer: C
By default, a trunk port sends traffic to and receives traffic from all VLANs. All VLAN IDs, 1 to 4094, are allowed on each trunk. However, you can remove VLANs from the allowed list, preventing traffic from those VLANs from passing over the trunk. To restrict the traffic a trunk carries, use the “switchport trunk allowed vlan remove vlan-list” interface configuration command to remove specific VLANs from the allowed list.
For security reasons, the IT manager has prohibited users from dynamically establishing trunks with their associated upstream switch. Which two actions can prevent interface trunking? (Choose two.)
A. Configure trunk and access interfaces manually.
B. Disable DTP on a per interface basis.
C. Apply BPDU guard and BPDU filter.
D. Enable switchport block on access ports.
300-115 pdf 
Correct Answer: AB
Which of the following groups would NOT be considered to be subject matter experts (SME’s) of a job function?
A. Current incumbents
B. Direct reports
C. Trained job analysts
D. D.Supervisours
Answer: B
Let’s assume you need to develop a strategic employer branding program. Which of the following
is one of the LEAST effective methods in prositive employer branding?
A. Providing above-market compensation packages
B. Gathering local confidence by socially responsible actions, ie environmentally conscious
C. Winning the Malcolm Baldrge National Quality Award
D. Implementation of flexible work arrangements that reduce turnover by 10%
300-115 vce 
Answer: A
What are the 4P’s in Marketing?
A. Place, Product, Promotion, Partnership
B. Price, Place, Product, Promotion
C. Price, Product, Promotion, Productivity
D. Price, Product, Promotion, Partnership
Answer: B

Which of the following is NOT a reason why a company would pursue moving forward with an
A. Improve customer relations
B. Increase their current market share
C. Acquire new skills and talents
D. Expand their product protfolio
300-115 exam 
Answer: A
Which of the following criteria is NOT a factor in determining the level of control of a non-U.S.
A. Labor relations centrally controlled
B. Principal place of business
C. Shared management
D. Interrelation of operations
Answer: B

The Pass4itsure provide more comprehensive information, including the current 300-115 dumps exam questions, with their wealth of experience and knowledge by Pass4itsure team of experts to come up against cisco certification https://www.pass4itsure.com/300-115.html dumps exam.

Read More Youtube:https://youtu.be/yzZU1yP0zbg

You may also like